Table of Contents
Advertisement
Select menu display language
Note
•
If this product is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
1
Press SETUP.
» [General Setup] menu is displayed.
2
Select [OSD Language], and then press .
3
Press
to select a language, and then press
OK.
Turn on progressive scan
Note
•
To use the progressive scan feature, you must connect a
progressive scan TV with the component video jacks (see
"Connect" > "Connect audio/video cables" > "Option 2:
Connect to the component video jacks" for details).
1
Turn on the TV to the correct viewing channel
for this product.
2
Press SETUP.
3
Press
to select [Video Setup].
4
Select [Progressive] > [On], and then press
OK.
»
A warning message is displayed.
5
To proceed, select [Ok] and then press OK.
»
The progressive setup is complete.
Note
•
If a blank/distorted screen is displayed, wait for 15
seconds for the auto recovery.
•
If no picture is displayed, turn off the progressive scan
mode as follows:
1) Press
to open the disc compartment.
2) Press the Numeric button '1'.
6
Press SETUP to exit the menu.
7
You can now turn on the progressive scan
mode on the TV (see the TV user manual).
Note
•
During play, when the progressive scan mode is on for
both this product and the TV, distorted picture may
display. In this case, turn off the progressive scan feature
on both this product and the TV.
Use Philips EasyLink
This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
•
To enable the EasyLink feature, you must turn on the
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press
to turn on this product.
»
The TV (if supports one-touch play)
automatically turns on and switches to the
correct video-in channel.
»
If a disc is loaded in this product, disc play
automatically starts.
One-touch standby
1
Press and hold
on the remote control for
more than 3 seconds.
EN
9
Advertisement
Table of Contents
