Samsung HW-J6500R User Manual page 16

CONNECTIONS
● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
● If the main unit is powered off,the wireless subwoofer will in standy mode and the STANDBY LED on the
front will blink Red directly. (no blue LED).
● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar,
interference may cause some sound interruption.
● The maximum transmission transmission distance of the wireless signal between the main unit and
subwoofer is about 32.8 ft, but may vary depending on your operating environment. If a steel-concrete or
metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all,
because the wireless signal cannot penetrate metal.
● If the main unit doesn't make a wireless connection, follow steps 1-5 on the previous page to re-set the
connection between the main unit and wireless subwoofer.
● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and
moisture.
● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear
of any obstructions.
LED INDICATOR LAMP STATUS ON SUBWOOFER
LED Status
Red
Blue
Blinking
Red and blue Blinking
Description
Standby (with the Soundbar main
unit turned off)
On
Connection failed
Successfully connected
On
(normal operation)
Standby (with the Soundbar main
unit turned off)
Connection failed
Malfunction
Check the power supply to the
(refer to the instructions on manual
connection in the user manual)
Check the power supply to the
(refer to the instructions on manual
connection in the user manual)
Contact the service center.
16
Resolution
Soundbar main unit
Connect again
-
Soundbar main unit
Connect again