York Fitness diamond x302 Owner's Manual page 9

6. Connect the upper and lower moving handlebars
1. Slide the lower moving handlebar up into the tube
of the upper moving handlebar
2. Choose a height adjustment hole and secure in
position with the pull plunger
3. Repeat for the other side, making sure to choose
the height adjustment hole in the same position
7. Attach the console to the handlebars
1. Push the console wires through the
square hole
2. Secure the console onto the bracket using
screws as shown (screws are located in
the back of the console)
8. Attach the handlebars
1. Open the handlebar clamp bracket and
place the handlebar inside
2. Close the clamp bracket and place the rear
handlebar bracket cover over it
3. Secure in place using the Multi-position
handle and screws as shown
4. Turn the handlebars to the fully upright
position
5. Connect the 2 sets of wires together and
then push them down into the inside of the
front post – through the narrow gap behind
the rubber stop
6. Finally, attach the front handlebar bracket
cover as shown
!
Make sure the handlebars are fastened securely
in place with the multi-position handle
25
91
38
90
111
25
FIXINGS: FIXINGS:
Part
No.
90
x 2
FIXINGS: FIXINGS:
Part
No.
111
x 4
FIXINGS: FIXINGS:
Part
No.
25
x 2
Part
No.
38
x 2
Part
No.
91
x 1
9