Samsung IFH User Manual page 91

Other issue
The product smells like plastic.
Video playback is choppy.
Small particles are found on the edges of the product.
When I try to change the PC resolution, a message
defined resolution is not currently supported." appears.
HDMI Black Level is not functioning properly on an HDMI
device with YCbCr output.
The IR sensor is not functioning.
In power-saving mode, when the input source is
DisplayPort, PC display settings cannot be saved.
When booting the PC with the input source set to
DisplayPort, the BIOS and booting screens do not appear.
The plastic smell is normal and disappears over time.
Check the cable connection and connect it again if required.
Using an excessively hard or thick cable may cause choppy video playback.
Make sure cables are flexible enough to ensure durability. When mounting the product onto a
wall, it is recommended to use right-angle cables.
The particles are part of the product design. The product is not defective.
The message "The defined resolution is not currently
"The
resolution exceeds the maximum resolution of the display.
To resolve the issue, change the PC resolution to a resolution supported on the display.
This function is available only when a source device, such as a DVD player and STB, is connected
to the product via an HDMI (RGB signal) cable.
Make sure the sensor light turns on when a button is pressed on the remote control.
• If the light does not turn on, turn the power switch off and then on again.
If the sensor light still does not turn on after the power switch is turned off and then on
again, an internal jack may be disconnected.
Contact your nearest service center to have the product serviced.
Go to System → Power Control
display output settings again. Ensure the set is turned on.
Boot the PC when the set is turned on or when the input source is not DisplayPort.
supported." appears if the input source
and set Max. Power Saving to Off. Alternatively, configure the PC
91