Panasonic KX-UDS124CE Important Information Manual page 2

Dect cell station unit (sip)
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Do not connect or disconnect the AC plug with wet hands.
Do not touch the SIP-CS, AC adaptor or AC adaptor cord during a lightning storm.
Do not allow anything to rest on the AC adaptor cord or LAN cable. Do not locate
the SIP-CS where the AC adaptor cord or LAN cable may be stepped on or tripped
on.
When installing or testing a SIP-CS with an external AC adaptor, the AC adaptor
should be plugged into a wall outlet or floor-mounted AC outlet. Do not connect the
AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause
it to become disconnected.
Make sure that you do not short the battery or cables.
Never attempt to insert wires, pins, etc. into the vents or other holes of the SIP-CS.
Do not splash water on the AC adaptor or the power cord, nor get them wet. Doing
so can result in fire, electric shock, or injury. If they do get wet, immediately
disconnect the AC adaptor and power cord, and contact an authorised service
centre.
Do not touch the AC adaptor for extended periods of time. Doing so can lead to
low-degree burns.
Do not make power connections that exceed the ratings for the AC outlet or power
equipment. If the power rating of a surge protector, etc. is exceeded, it can cause
a fire due to heat buildup.
Care should be taken so that objects do not fall onto, and liquids are not spilled into,
the SIP-CS. Do not subject the SIP-CS to excessive smoke, dust, moisture,
mechanical vibration, shock, or direct sunlight.
Do not place heavy objects on top of the SIP-CS.
Do not mount the SIP-CS in a manner other than that described in this manual.
The SIP-CS must only be installed and serviced by qualified service personnel.
The SIP-CS should be used as-is from the time of purchase; it should not be
disassembled or modified. Disassembly or modification can cause a fire, electric
shock, or damage to the SIP-CS.
Make sure that the wall that the SIP-CS will be attached to is strong enough to
support the SIP-CS (approx. 290 g). If not, it is necessary for the wall to be
reinforced.
Only use the wall-mounting equipment (screws, washers) included with the SIP-
CS.
When the SIP-CS is no longer in use, make sure to detach it from the wall.
2
WARNING

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-uds124

Table of Contents