Location Of The Surface Elements And Controls - Samsung NZ30K7570RS User Manual

Before you start
CAUTION
AFTER COOKING
• Do not touch the surface units until they have cooled down.
• The surface may be still be hot and burns may occur if you touch the glass
surface before it has cooled down sufficiently.
• Immediately clean spills on the cooking area to prevent a tough cleaning chore
later.
• If cabinet storage is located directly above the cooking surface, make sure
that the items in it are infrequently used and can be safely stored in an area
subjected to heat. Temperatures may be unsafe for items such as volatile
liquids, cleaners, or aerosol sprays.
About the radiant surface elements
The temperature rises gradually and evenly. As the temperature rises, the radiant
element will glow red. To maintain the selected setting, the element will cycle
on and off. The heating element retains enough heat to provide a uniform and
consistent heat during the off cycle. For efficient cooking, turn off the element
several minutes before cooking is complete. This will allow residual heat to
complete the cooking process.
NOTE
Radiant elements have a limiter that allows the element to cycle ON and OFF, even
at the HI setting. This helps to prevent damage to the ceramic cooktop. Cycling at
the HI setting is normal and can occur if the cookware is too small for the radiant
element or if the cookware bottom is not flat.
CAUTION
if the cooktop is installed above an oven, do not use the cooktop while the oven's
Self-cleaning function is on.
16 English
NZ30K7570R_DG68-00821B-04_EN+MES+CFR.indb 16

Location of the surface elements and controls

Cooking zones
01
04
06
01 Left Rear 02 Center
(7", 1500 W) (6"/9", 3300 W)
04 Left Front 05 Right Front
(7", 1500 W) (5"/8", 2000 W)
03
02
05
03 Right Rear
(6", 1200 W)
06 Control Panel
2018-03-09 12:04:15