Fujitsu ScanSnap iX1400 Basic Operation Manual page 70

No. Name
7 [Scan] button (*1)
8 Stacker
9 Receipt Guide
*1: When the ScanSnap has turned off automatically because of the automatic power off function,
perform the following to turn the ScanSnap back on.
l iX1600/iX1500
Press the touch panel, or close the ADF paper chute (cover) and open it again
l iX1400
Press the [Scan] button (this will not start scanning), or close the ADF paper chute (cover)
and open it again
For details, refer to
S1300i)" (page 100).
Back
No. Name
10 USB connector
11 Power connector
12 Security cable slot
13 Ventilation port
Description
Starts scanning. Can be pressed even when the stacker is closed.
Indicates the status of the ScanSnap as follows:
Blue (lit): Ready
Blue (flashing): Scanning
Orange (flashing): Error
Pull it out to use it.
Stacks up the ejected documents.
Attach it to the ADF paper chute (cover) for it to be used.
If you use the Receipt Guide, you can place documents with different
widths such as receipts in it to scan them at the same time.
"Automatic Power OFF (iX1600 / iX1500 / iX1400 / iX500 / iX100 / SV600 /
Description
Slide the cover of the USB connector up to open it and then connect
the USB cable to the USB connector.
The cover of the USB connector slides up either one or two levels.
Open the cover according to the type of the USB cable you have.
l First level: USB 2.0 cable
l Second level: USB 3.0 cable
Used to connect a power cable.
Used to connect an anti-theft security cable (commercially available).
Holes for ventilating hot air from inside the ScanSnap.
10
11
12
13
70
Parts and Functions