Sealey LED185W Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or
9
damaged DO NOT use.
Ensure the lamp is fully charged before initial use.
9
DO NOT charge in damp conditions.
8
DO NOT turn the lamp on when it is being charged.
8
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the lamp.
8
DO NOT handle or move the lamp whilst it is being charged.
8
DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulations.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
2. INTRODUCTION
Warm and comfortable beanie hat with a removable SMD spotlight. Features three light settings - full light (100%) medium light (75%) and
low light (50%). Includes wireless headphones for phone calls and music 2.4GHz transfer speed up to 10m. Removable lamp & speaker
chargeable via a USB port. Positioning of the LED gives a sufficient beam of light ahead of the user. LED and wireless speakers powered by a
rechargeable 3.7V 300mAh Lithium-Polymer battery. Supplied with USB charging cable.
3. SPECIFICATION
Model No: ..............................................................LED185W
Battery: ...............................................3.7V 300mAh Polymer
Charging Time: ..................................................................3hr
LED Qty: ..................................................................... 4 SMD
Lumen Output: ........................ 100%/75%/50%: 120/90/60lm
Operating Time: ...............................100%/75%/50%; 2/4/5hr
4. OPERATION
4.1. The light is operated by means of the on/off switch (fig.1):
4.1.1. The first press of the switch selects full power (120lm).
4.1.2. The second press, 75% (90lm).
4.1.3. The third press, 50% power (60lm).
4.1.4. To switch off, press for the fourth time.
fig.1
© Jack Sealey Limited
BEANIE HAT 4 SMD LED USB R/CHARGE
WITH WIRELESS HEADPHONES
LED185W
MODEL NO:
fig.2
Original Language Version
fig.3
LED185W Issue 1 05/07/19