Table of Contents
Advertisement
Enhancing your system
The connection cord is not included. Purchase a commer-
cially available cord as shown below.
Portable audio
player, etc.
Audio cable (not supplied)
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection cord to connect the portable audio
player, etc. to the AUDIO IN jack.
2
Press the ON/STANDBY button to turn the power on.
3
Press
the
INPUT
FUNCTION button repeatedly (main unit) to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
Headphones
Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
Before plugging in or unplugging the headphone, re-
duce the volume.
Be sure your headphone has a 1/8" (3.5 mm) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers au-
tomatically.
button
(remote
control)
Optical In
Connect to the TV using an optical digital cable.
DVD player/Digital
or
To select OPTICAL function:
Press the FUNCTION button repeatedly on the main unit
or INPUT button on the remote control until "Optical In"
appears on the display.
Note: TV Audio set up must be in PCM format.
E-19
TV
or
digital audio
Blu-Ray/
Optical digital
Tuner
(commercially
To OPTICAL
IN (optical)
input terminal
To optical
output
terminal
audio cable
available)
Advertisement
Table of Contents
