Table of Contents
Advertisement
To connect the cables required for proper operation, complete the following:
1. If external input or output devices are part of the installation (for example: door contacts, relays, etc.),
connect the devices to the I/O connector block.
2. If an external microphone or speaker is required, connect the devices to the audio connector.
3. Connect power using one of the following methods:
a. Power over Ethernet (PoE+) Class 4 — If PoE is available, the LEDs will turn on. If you are
connecting to the network using the SFP port, the Ethernet port and PoE will be disabled.
b. External Power — Connect an external 12 V DC or 24 V AC power source to the power
connector block. Use this power connection when connecting to the network using the SFP
port.
Note: The lens must be mounted before you power the camera.
4. Connect to the network using one of the following methods:
a. Ethernet port (RJ-45 connector) for 1000-BASE-T or 100-BASE-TX network connection.
b. SFP port (optical fiber using an SFP adapter) for 1000-BASE-SX or 1000-BASE-LX network
connection.
Connecting Cables
7
Advertisement
Table of Contents
