Installing The Turbocharger - ABB HT572043 Operation Manual

7.3
7.3
CAUTION
© Copyright 2016 ABB. All rights reserved.
Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
Removal and installation

Installing the turbocharger

Installing the turbocharger
Remove cover from oil connection.

Inspect lifting gear.

Fasten separate lifting gear to each of two bearing casing ribs provid-

ed for this purpose.
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be en-
sured that the orifice plates that are specified for the turbocharger have
been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.

Adapt turbocharger to suit engine.

Tighten fixing screws in foot in accordance with engine builder's in-

structions.
Fasten gas, air and oil lines in accordance with engine builder's in-

structions.
TPL65: Version with compressor wheel cooling system
Fit air supply line. (See also chapter Preliminary remarks / Layout and

functioning.)
Refit removed parts of insulation.

Plug in cable connector on speed sensor.

7
7.3 Page 84