Samsung SDS SHS-3320 User Manual page 8

3. Installing the Mounting Plate
D
Left-handed Right-handed
4. Installing the Magnetic Sensor
Left Trigger
5. Connecting the cable
C
B
1. Detach the Interior Mounting Plate from
2. According to the right or left handed door,
D
3. Fasten the interior mounting plate with
4. Align the Exterior Unit with the Interior
H2
5. Cover the rubber pad on the Interior
CAUTION: Do not over-tighten, and check
the movement of dead bolt by the mechani-
cal key.
Install the door side magnetic sensor.
It should be installed in right way of the door.
CAUTION: The gap of the magnet sensors
between the door side and the door-frame should
be within 3/4"(20mm). If the gap is to wide, pull out
Left Trigger
the door side magnetic sensor to adjust the gap
enough to detect.
3/4˝(20mm)
1. Connect the cable from the exterior unit to
the interior unit.
2. After connecting the cable, push the cable
into the hole of the door.

SHS-3320/3321
Samsung SDS
Digital Door Lock
the interior unit.
adjust the link, and attach the mounting
plate.
three TH+M5x40 (H2) 90% of the way.
Mounting Plate and then tighten the
screws.
Mounting plate.