Related Manuals for AIMS Power PWRI300012120S
Summary of Contents for AIMS Power PWRI300012120S
- Page 1 DC TO AC PURE SINE POWER INVERTER PWRI300012120S INSTRUCTION MANUAL ETL Listed to UL 458 and CSA 22.2 NO 107.1...
-
Page 2: Warning And Safety
A. INTRODUCTION The AIMS Power pure sine inverter product line is used for back-up power. The pure sine product line is ideal for sensitive equipment and provides clean power, which is more efficient for back-up power applications. The power inverter... -
Page 3: Inverter Features
13. The power inverter will output the same AC power as utility power, please treat the AC outlets as carefully as you would your home AC outlets. Do not put anything other than an electrical appliance into the output terminal. It may cause shock or fire. - Page 4 5. We recommend mounting the inverter on something stable to prevent it from bouncing. Impact shock could result in damage to your unit. Be sure to use all four mounting screws for optimal stability. Mount in a location that can support the weight of the inverter.
- Page 5 F. CONNECTION 1. Grounding The power inverter has a terminal on the rear panel marked " Grounding "or "≡". This is used to connect the chassis of the power inverter to ground. The ground terminal has already been connected to the ground wire of the AC output receptacle through the inverter.
- Page 6 SOFT START TECHNOLOGY The soft start technology built into this inverter protects the unit from delivering too much AC power at once by gradually increasing the AC voltage pushed out. To make sure that you are utilizing this feature, turn on the appliance being used before turning on the inverter.
-
Page 7: Troubleshooting Tips
115 VAC inverter is 1,250 VAC. For 230 VAC or dual voltage inverters, the hi-pot voltage is 1,500 VAC. This Aims power inverter is hi-pot tested before it leaves the factory, with a UL Certified hi-pot tester, set to the voltages shown... -
Page 8: Specifications
Do not use it when the battery is charging. Check the rated voltage of the battery and make sure it is in within the range of the input voltage. High input DC voltage Overload Reduce the load power. No output voltage, buzzer sounds continuously Cut off the load and let cool for 10 to 30 minutes. -
Page 9: Warranty
MODEL NO PWRI300012120S DC Input Voltage 12V (10-16V) Pure Sine Wave THD Output Wave Form <3% Output Power 3000W Surge Power Capacity 6000W for 40 milsec Efficiency Over 90% No Load Current DC 9.8 + _ 0.3V Battery Low Alarm DC 9.5 + _ 0.5V... - Page 10 AIMS be liable for indirect, special or consequential damages. This warranty only applies to AIMS Power branded products. All other name brand products are warranted by and according to their respective manufacturer. Please do not attempt to return non-AIMS Power branded products to AIMS Power.
Need help?
Do you have a question about the PWRI300012120S and is the answer not in the manual?
Questions and answers