Advertisement
3.3 Slide the domed cover over the base pillar.
3.5 fit another tube and secure to connecting
tube using 3 x allan bolts. Keep passing the
cable through the tubes. Repeat this
process for the last tube.
3.7 lower the head into position, aligning the two
screw holes in the head with those on the tube.
3.9 Carefully lay heater on its side. fix the cable to
the base using the two plastic cable clamps.
3.4 fit a connecting tube into the base tube and
secure with 3 x allan bolts.
3.6 Use assistance to support the heater head unit
and connect the feed cable, a simple push fit.
3.8 Using two cross head screws secure head unit.
3.10 Shows secured cable.
Original Language Version
EPH2100
Issue: 1 - 26/07/10
Advertisement
