Advertisement
1.2
GENERAL SAFETY INSTRUCTIONS
familiarise yourself with the applications and limitations of the heater.
Ensure the heater is in good order and condition before use. If in any doubt do not use the heater and
contact a qualified electrician.
only use recommended parts. To use unauthorised items may be dangerous and will invalidate your
warranty.
Check that element guards are in place, undamaged and firmly attached.
Site the heater at least 1m from any walls, obstructions or objects that may be affected by heat and
30cm minimum clearance from the ceiling.
Site the heater on a horizontal, flat and stable surface.
Disconnect from mains before moving or attempting any cleaning or maintenance.
Do noT use near bath tubs, wash areas or swimming pools.
Do noT use where gas, petrol, paint or other flammable goods are stored.
Do noT position immediately above or below an electrical socket.
Do noT leave turned on and unattended.
Do noT wind the power chord around the heater.
Do noT move the heater whilst in operation.
Do noT touch the heater elements, even when cold.
Do noT disassemble the heater for any reason. The heater must be checked by qualified personnel
only.
DO NOT use in the rain, although heater is shower proof it should not be used when raining or in
wet conditions.
Do noT use this product to perform a task for which it has not been designed.
WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating.
When not in use, store the heater carefully in a safe, dry, childproof location.
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood that common
sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2.
INTRODUCTION & SPECIFICATIONS
Stylish design made from aluminium with weighted base to help prevent toppling. Three settings from 900W to
2100W give controlled heat output. Produces a pleasant relaxing heat and is ideal for use in open workshops,
boat yards, forecourts, gardens and terraces. The heater element is situated approximately 2mtr off the ground
and the aluminium shade directs the heat downwards and outwards. for extra safety a tip switch is incorporated
to cut power should unit be accidentally knocked over. Supplied with 5mtr cable and BS approved 3-pin plug.
Power Settings: 900/1200/2100W
Supply:
230V 50Hz 13A
Height:
2100mm
Cable length:
5mtr
Weight:
15kg
3.
ASSEMBLY INSTRUCTIONS
3.1 Thread cable through base and into the base
tube. Pull through approx. 2mtr of cable.
3.2 fix the base tube to the base using the 3 x
m6 bolts.
Original Language Version
EPH2100
Issue: 1 - 26/07/10
Advertisement
