Advertisement
1
o'clock
Imprinted
triangles on
the stake
and the
fixture
Lens Tabs
Do not attempt to remove any bulbs while the fixtures are on or you may be burned.
7. Hold the stake with the cable at an angle of about 30°
(1 o'clock) to the floodlight housing as shown.
Press the stake with the cable down firmly into the piercing points
on the fixture.
If you have done this correctly, the fixture should light. If it doesn't,
make sure the power pack is on (and the photocell is covered to
block light), the piercing points are straight, and try again. You
can reposition the cable; the earlier holes created by the piercing
points will self-seal and not cause a hazard.
8. Lock the stake in place.
After the fixture has lit, turn the stake away from the imprinted
triangle on the fixture to lock it in place. Pull on the cable to
remove any slack.
9. Put the stake into the ground.
To install the stake, make a hole in the ground. Do not push the
stake into the ground without making a hole first because the
stake could be damaged. After you've inserted the stake, fill in
around it with dirt. Do not hammer or press hard on the lamp
assembly.
10. Adjust the light beam.
To adjust the light beam from narrow to broad, turn the lens
using the tabs.
IMPORTANT: To ensure your power pack isn't overloaded,
use a replacement bulb with the same wattage as the original
bulb. Maximum wattage allowed for this fixture is 7 watts.
! Possible Burns !
WARNING
Advertisement
