Table of Contents
Advertisement
Rev0 10.03.24
No.
Item
(cont.)
(cont.)
(3) Move the Elevator Arms down as shown in the picture below.
6
Hopper
Attachment
(4) Remove the Hopper Cover by removing 2 screws.
(5) Loosen the Hopper Attaching Screw at the left of the device and attach the Hopper
ASSY. See Note below. Lift the Hopper Plate so that the Elevator Arm will be under the
Hopper Plate.
(6) Secure the Hopper part with the screws and attach the Hopper Cover.
(7) Close the Main Cover by pushing the area of the "PUSH" labels that are both side of
the Main cover.
Hopper Attaching Screw
(Loosen)
NOTICE
Note:
much, which causes wrong attachment with a gap
and might be a cause of glitch.
Elevator Arm
At shipment
Hopper attaching
Magnified
view
Position
Hopper attached.
(Screw is removed)
Not loosen the Hopper Attaching Screw too
Procedure
Elevator Arm
Hopper Cover
Correct
where
Correct
No gap
-G4-
Elevator Arm
At installation
Hopper Plate
Side View
Hopper
Hopper
Wrong
Wrong
With gap
Advertisement
Table of Contents
