Husqvarna BG 250 Operator's Manual page 45

To do a check of the direction of
rotation of the motor BG 250
1. Push the startup support lever (A) rearward, to lift
the diamond tools from the surface.
C
B
2. Push the start button (B).
3. After some seconds, push the emergency stop
button (C).
4. Turn the fan clockwise and do a check of the
direction of rotation of the motor. The correct
direction is shown with an arrow on top of the fan.
5. If it is necessary, change the direction of rotation
of the motor. Refer to
rotation of the motor BG 250 on page 45 .
To change the direction of rotation of the
motor BG 250
1. Stop the motor. Refer to
on page 47 .
1802 - 002 - 13.04.2022
A
To change the direction of
To stop the product BG 250
2. Wait until the product is fully stopped.
3. Disconnect the power plug.
4. Turn the inverter switch in the mains plug to the
opposite position.
5. Connect the power cord and do a check of the
direction of rotation of the motor. Refer to
check of the direction of rotation of the motor BG 250
on page 45 .
To start the product BG 250
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Start the dust extractor.
2. Connect the dust extractor hose to the product.
To connect a dust extractor on page 42 .
Refer to
3. Stay behind the product.
To do a
Move the product all the
45