Download Print this page
Sealey SAC9002.V2 Quick Start Manual

Sealey SAC9002.V2 Quick Start Manual

9,000btu/hr portable air conditioner/ dehumidifier

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMP
P
OR
R TA
TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH
H E
P
P
RO
O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE
E
RS
S ON
N AL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Do not cover
instructions
1. SAFETY
1.1.
ELECTRICAL SAFETY
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of
appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. You
must also read and understand the following instructions concerning electrical safety.
Ensure that cables are always protected against short circuit and overload.
Regularly inspect power supply cables and plugs for wear or damage and check all connections
to ensure that none are loose.
Ensure that the voltage marked on the appliance matches the power supply to be
used and that the plug is fi tted with the correct fuse - see fuse rating at right.
DO NOT use worn or damaged cables, plugs or connectors. Have any faulty item repaired or
replaced immediately by a competent electrician.
It is recommended that this device is wired directly to a fused isolator switch. If, however, a plug
is fi tted, the following applies:
Fit a new plug according to the following instructions (UK only).
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected,
that the cable restraint is tight.
1.2.
GENERAL SAFETY
Check that the unit is in sound condition and good working order. Take immediate action to repair or replace damaged parts.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
NOTE: The appliance is designed for use with propane gas R290 only as it's designated refrigerant.
WARNING: The refrigerant loop is sealed. Servicing should only be carried out by a qualified technician.
DO NOT discharge the refrigerant into the atmosphere.
NOTE: Only install or operate in a room with a floor area exceeding 7m
DO NOT attempt any repairs or maintenance unless suitably qualified.
DO NOT stand or place any object closer than 500mm (20 inches) from the unit.
DO NOT obstruct the air intakes or outlets of the unit.
DO NOT cover with items of clothing.
DO NOT place any object into the outlets.
DO NOT operate the unit when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT switch the unit off by disconnecting it from the mains. ALWAYS switch it off using the Power button.
DO NOT remove the float lever from the water collection tank.
DO NOT connect or disconnect the plug from the mains with wet hands.
DO NOT use the unit outside.
DO NOT install or operate this air conditioner in a bathroom or other wet environments.
To prevent water from freezing, DO NOT use the unit at ambient temperatures below 0°C.
Always discard the water from the collection tank, DO NOT use it for any other purpose.
Place the unit on a level and stable surface.
If the appliance is tipped at an angle greater than 45°, leave it to stand for at least 24 hours before use.
Ensure that heating appliances are not exposed to the fl ow of air from the unit.
Before attempting to move the unit, empty the contents of the water tank. Use carrying handle (fi g1.3) when moving unit.
Switch off and disconnect unit from the mains before attempting any cleaning or other maintenance work.
Ensure that the unit is turned off correctly when not in use, and stored in a safe, dry area, out of reach of children.
NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
© Jack Sealey Limited
9,000BTU/HR PORTABLE AIR CONDITIONER/
DEHUMIDIFIER
SAC9002.V2
MODEL NO:
Indoor use
Caution:
only
risk of fi re
Original Language Version
2
.
SAC9002.V2 Issue 1 24/01/22
Recommended fuse rating
13 Amp

Advertisement

loading

Summary of Contents for Sealey SAC9002.V2

  • Page 1 DEHUMIDIFIER SAC9002.V2 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. R TA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Specification

    Screw fi t the hose connector to one end of the exhaust hose (fi g.3). 5.2.2. Screw fi t the window kit adapter to the other end of the exhaust hose (fi g.4). SAC9002.V2 Issue 1 24/01/22 Original Language Version © Jack Sealey Limited...
  • Page 3: Operation

    Sets a time for the unit to automatically START or STOP FAN SPEED Displays HIGH or LOW fan speed INDICATOR DIGITAL Displays timer setting and room temperature DISPLAY MODE Mode display between Cooling, Dehumidifying and Fan INDICATOR fi g.10 SAC9002.V2 Issue 1 24/01/22 Original Language Version © Jack Sealey Limited...
  • Page 4: Operation Mode

    Replace the electric plug into the power source and re-start the appliance in the desired mode.  WARNING! Ensure that the drain plug is fully inserted, otherwise the condensate water will fl ow out onto the fl oor. fi g.12 SAC9002.V2 Issue 1 24/01/22 Original Language Version © Jack Sealey Limited...
  • Page 5: Maintenance

    NOTE: The condensate water will automatically flow into the container or drain. 7. MAINTENANCE NOTE: Maintenance, service and repair must be carried out by qualified person. Contact your Sealey stockist for details. 7.1. CLEANING 7.1.1.
  • Page 6: Environment Protection

    BATTERY REMOVAL: REMOVE BATTERY FROM REMOTE Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.