Advertisement
3
Immersion Heater
1
Carefully remove front panel
by disconnecting the control
cable from beneath the unit's
main control box.
4
Reinstate plastic tab cover over
the connectors then insert the
thermostat rod into the upper
right hand pocket.
The terminals on the white
plastic head should be positioned
at the bottom as shown.
Assemble
and
7
Connector CNIH
2
Check before starting installation
that no water is in the tank.
The blanking plate and gasket
can be removed using a narrow
flat bladed screwdriver.
5
Screw positions
securely.
8
3
Diagonally locate the thermostat pockets on upper
right and bottom left with terminals on the upper left
and bottom right sides as shown.
Secure tightly with the nut to prevent water leakage.
(Recommended torque = 10 N•m)
Dispose
6
Align the centre lines 4
and 8 as shown.
Place the terminal
blocks so that the
orientations of the
Align the centre
labels are correct.
lines 6 and 9
as shown.
9
A1
A2
Optional parts
D-27
Advertisement
