Air-conditioners for building application, outdoor unit panel heater (224 pages)
Summary of Contents for Mitsubishi Electric PAC-IH03V2-E
Page 1
● Connections must be made securely and without tension on the terminals. The included component parts of the PAC-IH03V2-E IMMERSION HEATER (1Ph 3kW) shall be used only for the purposes indicated in the installation manual. D-25...
Page 2
Immersion Heater Optional parts Contents Item Piece Immersion heater Thermostat (High limit thermal cut-out) Tab cover Earth leakage breaker Screw (4×25) Relay Screw (4×16) Label (for Earth leakage breaker) Label (for Relay) Lead wire with connector Lead wire (Red, 130mm) Lead wire (Blue, 130mm) Lead wire (Red, 1500mm) Lead wire (Blue, 1500mm)
Page 3
Immersion Heater Optional parts Check before starting installation that no water is in the tank. Diagonally locate the thermostat pockets on upper right and bottom left with terminals on the upper left and bottom right sides as shown. Secure tightly with the nut to prevent water leakage. The blanking plate and gasket (Recommended torque = 10 N•m) can be removed using a narrow...
Page 4
Immersion Heater Optional parts Run the lead wire through the slit on the water-proof cover provided and seal each terminal screw. Do not insert the lead wires 3 and 4 into the opening that the main controller wires or the wireless receiver wires use.