About this manual This manual contains service and reference information for the following products: Lenovo 13w Yoga Machine types (MT): 82S1 and 82S2 Use this manual along with the advanced diagnostic tests to troubleshoot problems. Important: • This manual is intended only for trained service technicians who are familiar with products. Use this manual along with the advanced diagnostic tests to troubleshoot problems effectively.
Page 8
This practice ensures correct grounding of the units. • If an electrical accident occurs: – Use caution; do not become a victim yourself. – Switch off power. – Send another person to get medical aid. Lenovo 13w Yoga Hardware Maintenance Manual...
4. Check for cracked or bulging batteries. 5. Remove the cover. 6. Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo alterations. 7. Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water or other liquids, or signs of fire or smoke damage.
The safety notices in this section are provided in the following languages: • English • Arabic • Brazilian Portuguese • French • German • Hebrew • Japanese • Korean • Spanish • Traditional Chinese DANGER Lenovo 13w Yoga Hardware Maintenance Manual...
Checking the battery and operational charging Checking the battery This system supports only batteries specially designed for this specific system and manufactured by Lenovo or an authorized manufacturer. The system does not support unauthorized batteries or batteries designed for other systems. If an unauthorized battery or a battery designed for another systems is installed, the system will not charge.
Page 29
3. Check the battery status again. If the same error still exists, replace the system board. Chapter 2 General checkout...
CRUs, you can either install the CRU yourself or you can request that a Service Provider install the CRU according to the warranty service for your product. If you intend on installing the CRU, Lenovo will ship the CRU to you. CRU information and replacement instructions are shipped with your product and are available from Lenovo at any time upon request.
* for selected models Note: The Lenovo factory recovery USB key is used to restore the Microsoft Windows operating system. It might not come with the computer, and a user might order it from https://pcsupport.lenovo.com/ , though additional shipping and handling fees might apply.
• LCD cover sponge • Thermal pad for heat sink • Spec Label kit: • Label • Spec Looking up FRU information For detailed FRU information, including part numbers, descriptions, and substitution part numbers, go to: https://support.lenovo.com/partslookup Chapter 3 Locations...
Page 40
• Ensure that you use the correct screw. It is recommended to use new screws for replacements. If you have a torque screwdriver, tighten all screws firmly to the torque specified in the screw information table for each step. • Ensure torque screwdrivers are calibrated correctly following country specifications. Lenovo 13w Yoga Hardware Maintenance Manual...
Note: After you finish the servicing, ensure that you install the SD card back into the slot firmly. Removing the pen dummy (for selected models) If the computer you are servicing has a pen dummy installed, remove the pen dummy before you start the servicing. Lenovo 13w Yoga Hardware Maintenance Manual...
1010 Base cover assembly Removal steps of the base cover assembly Step Screw (quantity) Color Torque Black 0.294 Nm M2.5 × 7 mm, flat-head, nylon-coated (10) (3.0 kgf-cm) Chapter 5 Removing or replacing a FRU...
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive on a soft material, such as cloth, to absorb physical shocks. Removal steps of the M.2 2242 solid-state drive Notes: Lenovo 13w Yoga Hardware Maintenance Manual...
• A Mylar film might cover the solid-state drive. For access, peel off the film first. • The thermal pad is placed on the lower surface of the solid-state drive. Step Screw (quantity) Color Torque Black 0.181 Nm M2 × 3 mm, flat-head, nylon-coated (1) (1.85 kgf-cm) 1030 Wireless WAN card (for selected models) For access, remove this FRU:...
For access, remove this FRU: • “1010 Base cover assembly” on page 37 Removal steps of the memory module Note: A Mylar film might cover the memory module. To access the memory module, peel off the film first. Lenovo 13w Yoga Hardware Maintenance Manual...
When installing: Insert the notched end of the memory module into the memory slot. Press the memory module in firmly, and pivot it downward until it snaps into place. Ensure that the memory module is firmly installed in the slot and does not move easily. 1060 Wireless LAN card For access, remove this FRU: •...
Either too much or too less application of grease can cause a thermal problem due to imperfect contact with a component. For the new heat sink, you must peel the thin film off from the rubbers. Lenovo 13w Yoga Hardware Maintenance Manual...
1080 Rear camera and microphone module, bracket, and cable (for selected models) For access, remove these FRUs in order: • “1010 Base cover assembly” on page 37 • “1070 Heat sink” on page 42 Removal steps of the rear camera and microphone module, bracket, and cable Step Screw (quantity) Color...
When installing: Ensure that the connectors are attached firmly. 1090 Thermal fan For access, remove this FRU: • “1010 Base cover assembly” on page 37 Removal steps of the thermal fan Lenovo 13w Yoga Hardware Maintenance Manual...
Important notice for replacing a battery Attention: Lenovo has no responsibility for the performance or safety of unauthorized batteries, and provides no warranties for failures or damage arising out of their use. The Vantage app provides an automatic battery diagnostic test that determines if the built-in battery is defective. A built-in battery FRU should not be replaced unless this diagnostic test shows that the battery is defective.
• When you route the cables, ensure that they are not subject to any tension. Tension could cause the cables to be damaged by the cable guides, or a wire to be broken. 1110 P-sensor cable (for selected models) For access, remove these FRUs in order: Lenovo 13w Yoga Hardware Maintenance Manual...
• “1010 Base cover assembly” on page 37 • “1100 Built-in battery” on page 45 Removal steps of the Lenovo Integrated Pen charge board and cable Note: For wireless WAN models, additionally remove the wireless WAN antenna Cu foil assembly.
1140 System board Important notices for handling the system board: When handling the system board, read the following: • Some components mounted on a system board are very sensitive. Improper handling of a system board can cause damage to those components, and may cause a system malfunction. •...
1150 Power button with or without fingerprint reader For access, remove these FRUs in order: • “1010 Base cover assembly” on page 37 • “1140 System board” on page 49 Removal steps of the power button with or without fingerprint reader Lenovo 13w Yoga Hardware Maintenance Manual...
1160 Speaker assembly For access, remove these FRUs in order: • “1010 Base cover assembly” on page 37 • “1140 System board” on page 49 Removal step of the speaker assembly When installing: • Ensure that the connector is attached firmly. •...
Page 58
• “1010 Base cover assembly” on page 37 • “1100 Built-in battery” on page 45 Removal steps of the trackpad and trackpad cable Lenovo 13w Yoga Hardware Maintenance Manual...
Page 59
Step Screw (quantity) Color Torque M2 × 2.5 mm, flat-head, nylon-coated (2) Black 0.181 Nm (1.85 kgf-cm) When installing: • Install the trackpad in the direction as shown. Chapter 5 Removing or replacing a FRU...
For access, remove this FRU: • “1010 Base cover assembly” on page 37 Removal steps of the LCD unit Step Screw (quantity) Color Torque M 2.5 × 5 mm, flat-head, nylon-coated (4) Black 0.294 Nm (3.0 kgf-cm) Lenovo 13w Yoga Hardware Maintenance Manual...
When installing: Ensure that the connectors are attached firmly. 2030 LCD cable For access, remove these FRUs in order: • “1010 Base cover assembly” on page 37 • “1180 LCD unit” on page 54 • “2010 LCD strip cover” on page 55 •...
Removal steps of the camera and microphone module with microphone rubbers 2060 Gravity sensor board and cable For access, remove these FRUs in order: • “1010 Base cover assembly” on page 37 • “1180 LCD unit” on page 54 • “2010 LCD strip cover” on page 55 •...
Lenovo representative for information on the products and services currently available in your area. Any reference to a Lenovo product, program, or service is not intended to state or imply that only that Lenovo product, program, or service may be used. Any functionally equivalent product, program, or service that does not infringe any Lenovo intellectual property right may be used instead.
Page 68
Trademarks LENOVO and LENOVO logo are trademarks of Lenovo. Microsoft and Windows are trademarks of the Microsoft group of companies. The term HDMI is a trademark or registered trademark of HDMI Licensing LLC in the United States and other countries. USB-C is a registered trademark of USB Implementers Forum.