Related Manuals for Aquavolta H2-TURBO
Summary of Contents for Aquavolta H2-TURBO
- Page 1 Enhanced NANO-BUBBLES -TURBO Hydrogen booster 6th generation MANUAL by Karl Heinz Asenbaum Version 2022/01/18...
- Page 2 400 to 800 millivolts lower redox potential than tap water or bottled mineral water. • Due to its high readiness to release electrons, AquaVolta® is also called antioxidant water. However, it is not only used by doctors for therapy, but is also establishing itself as a modern everyday drink due to its pleasant taste •...
- Page 3 H and O are cleanly separated and only the hydrogen accumulates in the water. In addition, boosters such as the Aquavolta® H Turbo use pressure systems to dissolve as much H as possible in the water. In the 6th booster generation, it has now been possible to keep the gas bubbles so small that the efficiency of the booster has been significantly increased.
- Page 4 RO water We designed the AquaVolta® H - Turbo Hydrogen suitable! Booster so you don't have to rely on a single type of water. If you don't trust the tap water you have on...
- Page 5 5 - Device description / scope of Bottle thread for 30 mm bottles delivery Screw-in Pressure equalization production holes in the screw cap container 250 ml made of Tritan Do not block! Since bottles do Screw cap not have pressure equalization holes, this method is always second choice.
- Page 6 USB power supply with USB-C connector Seal Nasal cannula for H2 inhalation Lid for H2 inhalation...
-
Page 7: Operation Preparation
6 - Operation preparation B: Lid for H2 1. The device is built from 3 components. The H2 generator. The inhalation production vessel and a lid. The lid is available in 2 versions: A: Lid for H2 water production. B: Lid for H2 inhalation. Before commissioning, unscrew the production vessel, remove the orange silicone plug and keep it. - Page 8 7 - General instructions for use ► Only operate the device if you have read and ► Do not place the device outdoors understood the operating instructions. ► Do not use the power supply if it is damaged ► Before you switch on the unit, the water tank or the cable has been kinked.
- Page 9 7 - Preparation for operation and charging 1. Place the device on a dry flat surface. 2. Insert the USB-C plug of the power adapter and charger into the socket. The battery must be fully charged before first use. The LED starts flashing red. 4.
- Page 10 8 - Production hydrogen water or H inhalation Important: the device must be filled with drinking water before you press the start button. -Press the start button for 3 seconds. A beep indicates the start. Blue light turns on and you can recognize the hydrogen production by the fine bubbles rising.
- Page 11 • Store the device at room temperature and not in direct rinse the container with lid and the electrode several sunlight. times with warm water. Aquavolta® H - Turbo Technical data • This cleaning is also necessary for hygienic reasons at Weight (empty)
- Page 12 • Waste Electrical Equipment Register: WEEE Reg. No. DE 93599565 Leakage Check the seat and Adjust seals or replace with • Aquavolta® is a word mark protected by the German condition of the replacement seals if Patent and Trademark Office as well as by the EUIPO seals...
- Page 13 Please note the serial number here for service queries. You will find this on the underside of the H generator.
Need help?
Do you have a question about the H2-TURBO and is the answer not in the manual?
Questions and answers