Bosch GWS12V-30 Operating/Safety Instructions Manual page 13

6. After attaching the wheel, check that the
wheel is fitted correctly and can turn
freely before switching on the power tool.
Make sure that the disc does not brush
against the protective guard or other
parts.
TO REMOVE: Reverse procedure
FIG. 3
Cutting
Disc
Hex Key
Assembly
Clamping
olt with
Washer
-13-
Inserting and Releasing
Battery Pack
damaged, do not insert into tool. Battery
can fall out during operation.
Release battery pack (2) from tool by
pressing on both sides of the battery
release tabs (3) and pull downward (Fig. 4).
To insert battery, align battery and slide
battery pack into tool until it locks into
position. Do not force.
FIG. 4
If battery release tabs
are cracked or otherwise
3
2