Hitachi BD-SG100CJ Operating & Installation Instructions Manual page 29

Problem
●
Foam remains
on the door or
●
the door seal.
●
Fabric softener
overfl ows.
●
Fabric softener
remains.
●
There is
detergent
●
powder residue
in the detergent
case.
●
The washer
dryer switches
off during
operation.
●
●
Odor in the
washer dryer
●
●
Unsatisfactory
washing results
●
●
Unusual noise or
vibration
●
●
●
There is sound of
water when the drum
is rotated manually.
●
Tapping noise
comes out at
spin start.
●
Detergent case
is wet.
●
Water remains
in washer dryer
before initial use.
Possible Cause
You may have used too much detergent.
Laundry is new or not that soiled.
You may have exceeded the max. level of
softener in the detergent case.
The softener cover may have come out.
You may have used too much detergent.
You may have poured detergent in the
detergent case when it was wet. Wipe the
water away before adding detergent.
There may be noise from other electrical
appliances nearby such as a TV, a radio,
etc.
The motor may be locked due to overload,
the clothes being trapped in the rubber seal,
etc.
Rubber parts may give off a smell when you
fi rst start using the washer dryer.
There may be mold, dirt or detergent
residue on the drum.
You may have used too few detergent.
You may have poured detergent directly into
the drum.
The transport bolts may not have been
removed.
The washer dryer may be installed on a
sloping or unstable surface.
There may be foreign objects inside the
drum.
This is normal. Liquid is inside the 4-Ply
Liquid Load Balancer fi xed onto the drum to
make it balanced.
This is normal. Tapping sound is generated
when laundry touches to the laundry
protection bulge on the laundry inlet.
In some environmental or usage conditions,
Detergent case may get wet due to
condensation.
There may be drops of water or
condensation in the washer dryer due to the
factory inspection prior to shipment.
Solution
●
Use the appropriate amount of
detergent.
●
Do not pour in more than the
max. level of softener.
●
Firmly set the softener cover
on the detergent case.
●
Use the appropriate amount of
detergent.
●
Wipe the water away before
adding detergent.
●
Unplug the power cord and
plug in again. Then select
a program and start. Do not
place electrical appliances
close to the washer dryer.
●
This is not a malfunction. Wait
for about one hour and restart
the program.
●
The smell goes away over
time.
●
Run the Tub Clean program.
●
Use the appropriate amount of
detergent.
●
Pour detergent in the
appropriate dispenser.
●
Remove the transport bolts
before using.
●
Install the washer dryer on a
horizontal, stable surface.
●
Remove foreign objects such as
coins, pins, etc. from the drum.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.
29