Pair up with Surround R/L
Automatic Pairing
1
Plug the Soundbar and the Surround
R/L into the mains sockets and then
press on the unit or remote control
to switch the unit to ON mode. The
Surround R/L and Soundbar will
automatically pair.
» Determine the status based on
the Surround R/L indicator.
LED State
Fast blink
Slow blink
Constant on
2
Connect the Left and Right Surround
with RCA cable.
Tips
•
Do not press Pair button on the rear of the
surround except for manual pairing.
EN 20
Status
Surround R/L in Pairing mode
Pairing Failed
Connected / Pairing successful
RCA cable
RCA cable
Manual Pairing
If no audio from the Surround R/L can
be heard, manually pair up the Surround
R/L.
1
Both sound bar and wireless surround
speakers are on.
2
Press and hold (5 seconds) the Pair
button on wireless surround speaker
until the surround speakers Red LED
blink.
3
Press and hold Soundbar local keys
Play/Pause and Vol+ for 3 seconds.
4
The soundbar will discover and pair
with the surround speakers in pairing
mode.
» Main unit and surround speakers
shall discover each other and
pair, main unit display shows
"PAIRING".
» If pairing succeeds, main unit
display shows "SURR PAIRED" for
3 seconds.
» If pairing fails, main unit display
shows "CHECK SURR" for 3
seconds. If Soundbar cannot
know which device type has
failed to pair, main unit will show
"CHECK DEVICE" for 3 seconds.
When performing manual pairing, the
soundbar must be on. Pairing can only
be done one device per time. Refer
to Wireless Subwoofer and Wireless
Surround Speakers sections for details.