Philips ITS4843B Installation Manual page 69

Figure 3-1 shows the location of the IntelliVue Smart-hopping 1.4 GHz Core Access
Point LEDs.
IntelliVue Smart-hopping
IntelliVue Smart-hopping
A summary of the Core AP system status LEDs is given below to help you
troubleshoot any AP operational problems that may arise.
The IntelliVue Smart-hopping Core AP provides the following status LEDs.
• Wired/Ethernet Activity - The Core AP provides two LEDs to indicate wired/
Ethernet activity to the IntelliVue Smart-hopping infrastructure. During normal
operation, these LEDs indicate the following information:
-
-
• Wireless/RF Activity - The AP provides three LEDs to indicate wireless/RF
activity. During normal operation, these LEDs indicate the following information:
-
-
IntelliVue Smart-hopping 1.4 GHz Access Point Installation Guide
Link LED Activity LED
Power/Sync, Radio,
and Network
Status LEDs
Ethernet Interface to
Sync Unit
Ethernet Interface to
Sync Unit
Activity LED
Link LED
Power/Sync, Radio, Network
Status LEDs
Figure 3-1: IntelliVue Smart-hopping Core Access Point LEDs
Link LED - Link present/Ethernet connection. Lights GREEN (ON) when a
pass-through link is present - OFF when not present.
Act LED - Wired network activity. Flashes GREEN (ON) when there is activity is
over the wired network.
Power/Sync LED - GREEN (ON) when power and synchronization signal is
present.
Radio LED - Normally OFF (not lit) - flashes green to indicate wireless network
activity.Network LED - Normally OFF (not lit) - flashes green to indicate wired
network activity.
Troubleshooting the Core AP Using its LEDs
Ferrule Cable Connectors
to Remote Antennas (2 & 1)
RA 2
RA 2 RA 1
Serial Port Fiber Cable Connectors
to Remote Antennas (2 & 1)
with RA Status LEDs
ITS4843D Core Access Point
RA Power LEDs
RA Connection LEDs
ITS4843B/C Core Access Point
RA 1
3-3