Table of Contents
Advertisement
RAPT Pill Hydrometer & Thermometer Quick Start Guide
Calibration before first use is strongly encouraged for best results.
1. Plug your Rapt Pill into a charger or computer with a USB-C cable (not included).
2. On your smart phone or tablet, open your Wi-Fi settings and connect to the "RAPT Pill XXX"
access point (AP) using the password "kegland1". You may not need to enter the password if
you have previously connected your device to the Pill's Wi-Fi.
3. Open the Pill Captive Portal when prompted to sign into the network of your RAPT Pill by
your smart phone or tablet.
If you are not prompted to sign into the network of your RAPT Pill by your smart phone or
tablet then open your Wi-Fi settings and select the "RAPT Pill XXXX" Wi-Fi network again to
open the Pill Captive Portal.
3. Once the RAPT Pill Access Portal is open on your phone or tablet, navigate to the Calibration
tab.
4. Select the desired calibration method (Standard,
relevant steps.
IMPORTANT: The RAPT Pill is designed to disconnect from the RAPT Portal once the USB-C cable is
unplugged to preserve battery life. Opening the Calibration or Diagnostics screen will keep the Pill
Portal active to allow calibration of the Pill. You will be prompted after to 10 minutes to "Click
Here To Maintain Connection" if the calibration process takes longer than 10 minutes.
Once you have entered a Calibration mode, please assemble your Pill according to the directions so
that it can be removed from the USB and calibrated according to the instructions below.
There are three ways to calibrate your RAPT Pill:
Custom
Calibration.
10
18
Page
of
Calibration
Standard
www.KegLand.com.au
Advanced
or Custom) and follow the
Calibration,
Advanced Calibration
Last Updated 6/05/2022 16:49 PM
and
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RAPT PILL and is the answer not in the manual?
Questions and answers