Hitachi CP-X2520 Service Manual page 50

4. POWER FAN
Put the POWER FAN onto the BALLAST HOLDER so that two bosses of the
BALLAST HOLDER fit to holes of the POWER FAN.
Fasten the POWER FAN with 2 screws.
BALLAST HOLDER
Confirm that the slit of the POWER
FAN is beside the projection of a
BALLAST HOLDER after attaching
the POWER FAN.
5. Power Supply Block
Fasten the BALLAST HOLDER and the POWER SHIELD METAL to the POWER UNIT CIRCUIT
with four screws. (Torque: 0.39 to 0.59N m)
Attach the power supply block to the BOTTOM CASE.
Fasten the power supply block
Secure down the INLET
METAL to secure the AC
INLET.
T2.6x12 screw
AC INLET
INLET METAL
CP-X2520 ( M2-25ED ) / CP-X3020 ( M2-30ED )
M4x8 screw with washer (1pc)
M3x8 screw (3pcs)
AC INLET
POWER UNIT BLOCK
LAMP HOUSE
50
2 bosses
POWER FAN
T3x12 screw
with washer (2pcs)
with T2.6x12 screws.
Fasten to BOTTOM CASE
T2.6x12 screw
Secure to
LAMP HOUSE
T2.6x12 screw