Hitachi CP-X2520 Service Manual page 40

Wiring of MAIN board 2
(1) Wire CNTS, CNLAP, CNBAR and #3040
(2) Connect CNGD1, #3020 and speaker cable
Fasten the CNTS cable
with the bosses. Push
the wires into the end.
Secure the CNTS and
the CNBAR with a
tape ZTP3.
Fasten the CNBAR
with the bosses. Push
the wires into the end.
Fasten the #3040 with the
bosses. Push the wires
into the end.
Pass the #3040 under the CNBAR
so that the #3040 cable is not
apart from the casing.
Style the TSW cable
winding into the bosses.
Fasten the TSW cable and
#3040 into the bosses. Pass the
#3040 under the TSW cable.
Pass the TSW cable under the
CNLAP so that the TSW cable is
not apart from the casing.
Pass a wire of the TSW cable between the
rib and the boss. Pay attention not to pass it
over the rib.
Wiring diagram 9
Pass the speaker cable over any other
cables as keeping away form the crimp.
Fasten the rounds to the
I/O metal with screws.
CNPGD1
NG
Speaker cable passing
over the crimp
Connect #3020.
Connect the
speaker cable.