JVC 330 Service Manual page 6

Safety
WARNING!!!
all service to factory authorized personnel.
Ultraviolet radiation, dangerous glare, and high internal gas pressure
is present at the Xenon Arc Lamp. It is contained in a protective reflector housing
module.
DO NOT operate the Xenon Arc Lamp outside its intended standard housing or outside
of the projector.
When replacement is required, the arc lamp must be replaced as an entire module as
outlined in the Hughes-JVC Model 330, 340SC and 370SC Projector Service Manual.
No attempt should ever be made to replace the arc lamp inside its module!
The arc lamp produces dangerous intense light with hazardous levels of ultraviolet and
infrared radiation. It operates at high temperatures (180ºC, maximum 300º C or over 500º
F).
Do not touch the xenon arc lamp or any connections when the lamp is ignited or is arcing.
WARNING!!! BRIGHT LIGHT!
Lamp, the lighted Projection Lens, or into the lamp housing, from any distance,
when the projector is ON and light is projected. Direct exposure to light of this
brightness can cause severe eye injury.
WARNING!!!
restricted to factory authorized service personnel!
WARNING!!!
Allow at least one minute to bleed off high voltage even after the unit has been turned off.
Due to high voltage danger, DO NOT TOUCH:
White cables to CRTs—these cables can cause severe shock from a tiny, invisible
!
crack or hole and should never be touched while projector power is on.
CRT anodes—underneath the CRTs.
!
Main power +/- supply posts—if shorted with metal objects,
!
80 amps can flow across the terminals.
!
viii
High temperature, ultraviolet and infrared light. Refer
High voltage access and safety interlock. Defeat
High voltage points up to 40,000 volts are exposed inside the covers.
Model 330, 340SC, and 370SC Service Manual
Never look directly at the Arc