Terminals; Terminal Preferences; Terminals And Communication Protocol - JVC 250 Service Manual

Chapter 8---Software and Protocol
8.3 Terminals and Communication Protocols

Terminals

The projector can be controlled by a VT-100 terminal. If a VT-100 is not
available, a PC with Windows 3.1 or ProComm for DOS can emulate a VT-100.
Table 8-1 shows the equivalent commands for the terminal and both remotes.
1. From Windows Program Manager, select TERMINAL then SETTINGS.
2. Select TERMINAL EMULATION from SETTINGS menu.
3. Select DEC VT-100 (ANSI) (may already be selected).
4. Use a Null Modem cable to connect between the projector and the
terminal.
5. Use the TERMINAL PREFERENCES and COMMUNICATIONS
PROTOCOL below for Windows setup.

Terminal Preferences

Select SETTINGS again from the menu bar. Select TERMINAL
PREFERENCES. Set the following modes:
Table 8-1 Terminal preference settings
Line Wrap
Local Echo
Sound
Columns:
80:
132:
Terminal Font:
Courier 12
Terminal Show:
Scroll Bars
Use Function Arrow
and Control keys for
Windows
8-10
Yes CR"CR/LF:
No Inbound
Yes Outbound
Cursor:
Yes Block:
No Underline:
Blink:
Translations
IBM to ANSI
Yes Buffer Lines
No
No
No
Yes
No
Yes
NONE
No
100
Model 250 Service Manual