Bosch CS 550 Operator's Manual page 17

All manuals and user guides at all-guides.com
Warning Messages
ANTI-ICING PULSES/GAL TOO HIGH
SPNR WIDTH AT 0 RPM TOO LOW
SPNR WIDTH PER RPM TOO LOW
GATE MOVEMENT TOO LOW
GATE ZERO IN MANUAL
GATE AT CALIBRATION TOO LOW
SPINNER SENSOR PULSES TOO LOW 58
CONV SENSOR PULSES TOO LOW
SPINNER OUTPUT RANGE TOO LOW
CONV OUTPUT RANGE TOO LOW
CROS CONV1 OUTPUT RANGE LOW
CROS CONV2 OUTPUT RANGE LOW
PREWET OUTPUT RANGE LOW
ANTI-ICING OUTPUT RANGE LOW
JOY1 OUTPUT RANGE TOO LOW
JOY2 OUTPUT RANGE TOO LOW
REQUIRED CONV RPM TOO HIGH
REQUIRED PREWET FLOW TOO HIGH 69
REQUIRED ANTI-ICING FLOW TOO HI
# Suggested Solution
52 Check anti-icing sensor, and recalibrate
53 Check spinner sensor, and recalibrate
54 Check max width, and recalibrate
55 Range too small (Low -> High)
56 Manual Gate set to 0
57 Calibrated gate needs tob a non-zero value
Spinner sensor pulses 0 or too low
59 Conv sensor pulses 0 or too low
60 Range between spn Min and Max too small
61 Range between Conv Min and Max too small
62 Range between Cros1 Min and Max too small
63 Range between Cros1 Min and Max too small
64 Range between prewet Min and Max too small
65 Range for anti-icing Min to Max too small
66 Range between Joy1 Min and Max too small
67 Range between Joy2 Min and Max too small
68 Setpoints too high, incorrect wt/rev
Setpoints too high, incorrect pulses/gallon
70 Setpoints too high, incorrect pulses/gallon
Bosch Rexroth Canada ı 07.22.2013 ı Revision 2.0
17/18