ENGLISH (Original instructions) SPECIFICATIONS Model 4403 Collet chuck capacity 6 mm (1/4") No load speed (min 30,000 Max. width of work 123 mm Max. width of work (45°) 77 mm Max. height of work 185 mm Transverse travel of table (bed)
Do not expose power tools to rain or wet Power tool use and care conditions. Water entering a power tool will 18. Do not force the power tool. Use the correct increase the risk of electric shock. power tool for your application. The correct Do not abuse the cord.
Check the bit carefully for cracks or damage FUNCTIONAL DESCRIPTION before operation. Replace cracked damaged bit immediately. Avoid cutting nails. Inspect for and remove all CAUTION: nails from the workpiece before operation. Always be sure that the tool is switched off and •...
Use the angle gauge for the angle work. Secure it to the Adjusting the motor height table (bed) using the wing nut. Then fasten the workpiece in position as shown in the figure. If the workpiece is big 1. Knob or long, remove the chip guard (chip deflector).
If you need any assistance for more details regarding MAINTENANCE these accessories, ask your local Makita Service Center. Drill point sash router bit CAUTION: Always be sure that the tool is switched off and • unplugged before attempting to perform inspection or maintenance.