Advertisement
CAUTION
●
Do not slide the cooling head over the skin.
●
Do not keep the cooling head in the same area of the skin, but move it around.
The cooling effect of the cooling head may be lessened.
4 After 1 minute and 50 seconds have elapsed, the device will be automatically shut off.
(Automatic Shutoff Function)
●
The finish sound will inform you.
When the "COOL" mode is finished, the main body and the cooling head become
●
slightly hot, however this is not unusual.
●
If a toner/moisturizing product remaining on the skin attaches to the cooling head or
the main body, please wipe off with a tissue.
CAUTION
If all of the mode indicator lamp and the level indicator lamp start flashing and the
abnormality detection sound beeps during use, this is a warning of device failure.
Pull out the power adaptor from the electric outlet, and contact the distributor for
repair.
About Skin Sensing Function
●
This device is a product which operates through the human body. Applying the skin to
the back plate and the head will make an electrical circuit start to operate.
Unless you touch the back plate and apply the head to the skin, it will not start to operate.
About Memory Function
This device is equipped with a memory function to store memory of the electrical
potential "strength" levels of "H," "M," or "L".
In each usage mode (Step 1 to 3), the device stores memory of the "strength" level just
before the automatic shutoff or the power switch is turned "off." If the level switch button
is pressed while the device is being used, the electric potential "strength" can be switched.
Care for Main Body
●
Wipe off any remaining cosmetic on the heating dimple head, spot sensor, cooling head,
main body and ring with a tissue paper, etc.
When it is difficult to remove dirt, wipe it off with a cotton-tipped swab or a cloth tightly
●
wrung out after saturating it with water.
Do not clean the main body with water. Do not soak in water,
and do not pour water on the main body. (Cause of failure)
Do not soak the head in boiling water or dry it with hot air.
(Cause of failure)
Make sure to turn OFF the switch. (Improperly turning on the switch
may give a tingling sensation or result in short-circuit.)
Do not use alcohol, benzine, or thinner.
(Cause of deformation or discoloration)
Do not rub the spot sensor with a hard brush such as a scrub brush.
(Cause of scratches and malfunctions of spot sensor)
How to Preserve
●
Attach the included protective cap to the main body and store it in a place with little
humidity and dust after cleaning.
●
The protective cap can be attached with the ring attached to the main body.(Fig.15)
Fit the hook to the neck.
Hook
Neck
-14-
Advertisement
