11/13/2016
5.7 Clearance adjustment (Fig.3)
TOP PREVIOUS NEXT
1. Insert the clearance gauge between the upper cutter surface of spinner (extractor) and the bottom of feeder
opening. (Fig.3)
2. when the thinner side (1/51''... 0.5mm) can be inserted and the thicker side (1/28''... 0.9mm) cannot, the
clearance is appropriate.
3. If the thicker side (1/28''... 0.9mm) can be inserted, the clearance is too large.
In that case, remove the coupler and add some adjustment washers onto the motor shaft.
4. In the thinner side (1/51''... 0.5mm) cannot be inserted, the clearance is too narrow.
In that case, remove the coupler and take off some adjustment washers from the motor shaft.
TOP PREVIOUS NEXT
file:///C:/Users/sh.dehghani/Desktop/MJW176PWTC/MJW176PWTC/SVC/s0507000000.html#5.7
s0507000000.html
(Fig.3)
1/1