Overview
This section describes the programming and setup of
the Professional Series radios for use with a Zetron
ZR310 repeater controller in a "community" repeater
configuration. Two Professional Series radios are
required; one operates as the receiver for the repeater
and the other operates as the transmitter of the
repeater. For more information on the ZR310, please
refer to the following manual:
6880904Z64
ZR310 Community Repeater Panel
Service Manual
Programming
Programming Tools
Use the Professional Series Customer Programming
Software (CPS) to program the receive radio and the
transmit radio (or use archived CPS files for the radios)
for the desired repeater configuration.
Refer to the ZR310 service manual, 6880904Z64, for
ZR310 controller programming information.
Professional Series Radios
Receive Radio Programming
1. Read the Professional Series receive radio.
2. After the radio is read, select "Radio Configu-
ration" from the opening CPS "Tree View"
window.
3. Click the "Accessory Configuration" tab.
4. Click the "Rx Audio Type:" dropdown arrow
button. Select "Flat Audio".
5. Click the "Ignition Sense Type:" dropdown
arrow button. Select "On/Off & Ignition".
Your
screen
should
Figure 9-1.
6. Click the "Accessory Pins" tab.
7. Click the "Accessory Package" dropdown
arrow button. Select "Community RPTR
(ZR310) Rx". Verify that pin 4 is "CSQ Detect
(Output)", Active Level "High". Your screen
should appear similar to Figure 9-2.
March, 2001
Programming the Professional Series Radios
for use with a ZR310 Repeater Controller
appear
similar
6864110R66-O
Figure 9-1. Radio Configuration, Accessory
Configuration, Receive Radio
to
Figure 9-2.
Radio Configuration, Accessory Pins,
Section 9
Receive Radio
9-1