Discharge Chute - Cub Cadet S6031 Operator's Manual
Liquid propane gas lawn mower
Hide thumbs
Also See for S6031:
- Brochure & specs (2 pages) ,
- Brochure (4 pages) ,
- Operator's and service manual (32 pages)
Table of Contents
Advertisement
Connecting the Battery Cables
CALIFORNIA PROPOSITION 65 WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION:
connect the POSITIVE (Red) wire to its terminal first,
followed by the nEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment
may have been left disconnected from the terminals at the
factory. To connect the battery cables, proceed as follows:
1.
Using the lever on the back of the seat frame, lift up on the
lever and tilt the seat forward.
NOTE: The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked neg. (–).
NOTE: If the positive battery cable is already attached, skip
ahead to step 2.
2.
Remove the plastic cover, if present, from the positive
battery terminal and attach the red cable to the positive
battery terminal (+) with the bolt and hex nut. See Fig. 3-12.
3.
Remove the plastic cover, if present, from the negative
battery terminal and attach the black cable to the negative
battery terminal (–) with the bolt and hex nut. See Fig. 3-12.
4.
Position the red rubber boot over the positive battery
terminal to help protect it from corrosion.
NOTE: If the battery is put into service after the date shown
on top/side of battery, charge the battery as instructed in the
Maintenance section your Operator's Manual prior to operating
the tractor.
14
s
2— a
ectiOn
sseMbly
When attaching battery cables, always
Figure 3-12
& s
-u
et
p
Discharge Chute
Remove the strap or any other device securing the mower deck
:
dischage chute during shipping. The discharge chute is a spring-
loaded device that must be down for proper and safe operation.
Tires
The tires are over-inflated during shipping to set the bead lock,
so they must be adjusted.
Inflation Pressure
•
Traction Tires — 20 psi max, 10-12 psi recommended
•
Front Wheel — 25 psi max, 20-25 psi recommended
Advertisement
Table of Contents
