Cub Cadet S6031 Operator's Manual page 12

Initial LPG Tank Fill-Up
NOTE: The vapor withdrawal service valve of the Aluminum
Outdoor Equipment Propane Cylinder is fitted with left-hand
threaded safety coupler. Typical forklift cylinders withdraw liquid
propane and have right-handed safety couplers. The different
safety couplers prevent users from installing cylinders on the
wrong equipment.
The LPG tank is shipped separately and will need to be purged
before the initial fill-up.
It is important to properly purge new propane cylinders before
the first fill. The authorized LP-Gas filler should follow proper
purge guidelines outlined in nPGA Bulletin #133.89(a).
Once properly purged, fill the cylinder through the fill valve with
Overfill Prevention Device (OPD) in accordance with section 7.4
of the Liquefied Petroleum Gas Code, nFPA 58-2008.
Installing the LPG Tank
1. Open the straps and carefully place the LPG tank into the
straps with the cylinder valve guard towards the front of
the unit. Be sure that the alignment pin fits into the slot on
the bottom of the cylinder valve guard. See Fig. 3-7.
Cylinder Valve Guard
Slot
Alignment Pin
12 s 2— a
ectiOn sseMbly
Figure 3-7
& s -u
et p
2. When the tank is in place, secure it by locking down the
straps (A). See Fig. 3-8.
B
C
Figure 3-8
3. Install the regulator hose on the LPG tank fuel valve (B) and
secure it by twisting it counter-clockwise(C). See Fig. 3-8.
NOTE: The hose has left-handed threads to prevent
improper usage.
Steering Wheel
To adjust the distance of the steering wheel column to the
operator's seat:
1. Pull the adjustment lock lever back toward the operator's
position to loosen the column. See Fig. 3-9.
Figure 3-9
2. Place the column in the desired position and then lock it
into place by turning the adjustment lock lever towards the
front of the tractor until secure.
A
A
Tighten
Loosen