Dual-Function Control Panel Model Cmxeocg572; Door Control Model Cmxeocg322 - Craftsman CMXEOCG322 Owner's Manual

DUAL-FUNCTION CONTROL PANEL
MODEL CMXEOCG572
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door
control to the garage door opener, press the push bar until the garage
door opener activates (it may take up to 3 presses). Test the door
control by pressing the push bar; each press of the push bar will
activate the garage door opener.
Push Bar
LIGHT Button
PUSH BAR: Press the push bar to open or close the door.
LIGHT BUTTON: Press the LIGHT button to turn the garage door
opener lights on or off. When the lights are turned on they will stay on
until the LIGHT button is pressed again, or until the garage door
opener is activated. Once the garage door opener is activated the
lights will turn off after the specified period of time (the factory default
is 4-1/2 minutes). The LIGHT button will not control the lights when
the door is in motion.
To change the amount of time the lights stay on:
Press and hold the LOCK button (approximately 10 seconds) until the
garage door opener lights flash. The time interval is indicated by the
number of times the garage door opener lights flash:
• 1 flash is 1-1/2 minutes
• 2 flashes is 2-1/2 minutes
• 3 flashes is 3-1/2 minutes
• 4 flashes is 4-1/2 minutes
To cycle through the time intervals repeat the step above. If the push
bar LED is continuously blinking, the LOCK feature needs to be
turned off.
Command LED
LEARN Button
LOCK Button
LEARN BUTTON: Any compatible remote control, wireless keypad,
®
or myQ devices can be programmed to the garage door using the
LEARN button.
LOCK: Prevents the garage door opener from being activated by
remote controls while still allowing activation from the door control
and wireless keypad.
Turn ON:
Press and hold the LOCK button for 2 seconds. The command LED
will flash as long as the lock feature is on.
Turn OFF:
Press and hold the LOCK button for 2 seconds. The command LED
will stop flashing and normal operation will resume.
TIMER-TO-CLOSE (DO NOT enable on one-piece doors)
The Timer-to-Close feature is not available on all door controls.
Below is a list of door controls with the Timer-to-Close feature:
The Timer-to-Close feature automatically closes the garage door
after a specified time period. DO NOT enable TTC if operating a
one-piece door. TTC is to be used ONLY with sectional doors.
Factory default is set to off. The garage door opener will beep and the
lights will flash before closing the door. The TTC feature will
deactivate if the garage door encounters an obstruction twice; or the
safety reversing sensors are incorrectly installed. The garage door
will reverse open and WILL NOT close until the obstructions are clear
or the safety reversing sensors are correctly installed. When the
obstruction has been cleared or the safety reversing sensors have
been aligned, the door will close when the garage door opener is
activated. TTC WILL NOT work if the garage door opener is operating
by battery power or if the safety reversing sensors are misaligned.
This feature is NOT intended to be the primary method of closing the
door. A wireless keypad should be installed in the event of an
accidental lock out when using this feature.
DOOR CONTROL
MODEL CMXEOCG322
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door
control to the garage door opener, press the push button until the
garage door opener activates (it may take up to 3 presses).
Push Button
35