Position The Opener - Craftsman CMXEOCG322 Owner's Manual

INSTALLATION STEP 4

POSITION THE OPENER

Follow instructions which apply to your door type as illustrated.
SECTIONAL DOOR OR ONE-PIECE DOOR WITH TRACK
A 2x4 laid flat is convenient for setting an ideal door-to-rail distance.
1. Raise the opener onto a stepladder. You will need help at this
point if the ladder is not tall enough.
2. Open the door all the way and place a 2x4 laid flat on the top
section beneath the rail (Figure 1).
3. If the top section or panel hits the trolley when you raise the
door, pull down on the trolley release arm to disconnect inner
and outer sections. Slide the outer trolley toward the motor
unit. The trolley can remain disconnected until Installation
Step 12 is completed.
Trolley
Release Arm
ENGAGED
ONE-PIECE DOOR WITHOUT TRACK
A 2x4 on its side is convenient for setting an ideal door-to-rail
distance.
1. Raise the opener onto a stepladder. You will need help at this
point if the ladder is not tall enough.
2. Open the door all the way and place a 2x4 on its side on the
top section of the door beneath the rail (Figure 2).
3. The top of the door should be level with the top of the motor
unit. Do not position the opener more than 4" (10 cm) above
this point.
RELEASED
To prevent damage to garage door, rest garage door opener rail
on 2x4 placed on top section of door.
Figure 1
Rail
Door
Figure 2
Header Bracket
Top of Door
16
2x4 is used to
determine the correct
mounting height
from ceiling.
2x4 is used to
determine the correct
mounting height
from ceiling.