Table of Contents
Advertisement
Fault Finding Guide
Fault Finding Guide
PROBLEM
1
Gate does not move:
2
Gate does not move, but the
relays "click" for +/- 2 seconds
when the unit is activated:
3
Gate does not move, but the
relays "click" and drop out
immediately.
4
Gate moves a short distance
and stops:
POSSIBLE CAUSES & SOLUTIONS TO PROBLEM
!
Check that you are
must be OFF.
!
LCK (lockout) input activated
ON.
!
IRB (IR beams) input activated (Gate will not close once
open)
. Green IRB light should be ON. Check cabling, and
12V power (3A auxiliary fuse).
!
Latching input on TRG or FRX
must be off for gate to operate.)
!
Check the battery condition with procedure
voltage condition,
!
If STATUS light flashes 4 times then the operator is in
Multiple Collision Mode
wait 60 seconds to reset operation. If required, check with
B: False collision detection
procedure
section.
!
If the problem persists, the
faulty.
!
Motor brushes could be faulty.
!
Check the motor wires.
!
Check 16A fuse and connections.
!
If STATUS light flashes 4 times then the operator is in
Multiple Collision Mode
possible obstructions. Remove & reapply all power, or
wait 60 seconds to reset operation. If required, check
B: False collision detection
with procedure
section.
! Faulty battery. Check the battery condition with procedure
A: Low battery voltage condition,
light flashes 3 times.
!
If the problem persists, the
faulty.
! Check the battery condition with procedure A: Low battery
voltage condition, especially if the STATUS light flashes 3
times.
Page 35
out of programming mode
. Green LCK light should be
. (Both TRG and FRX lights
later in this section.
. Remove & reapply all power, or
CP80
main controller might be
. Check for and remove
especially if the STATUS
CP80
main controller might be
, SET light
A: Low battery
, later in this
, later in this
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the D3 and is the answer not in the manual?
Questions and answers
Hello. How do i add new remote on d5v1.073. I cannot find the master
To add a new remote to the Centurion D3 when the master remote for the D5V1.073 is not available, follow these general steps:
1. Access the Controller: Open the gate motor housing to access the CP80 controller.
2. Enter Programming Mode:
- Press and hold the programming button on the controller until the LED lights up or blinks (exact behavior depends on the model).
3. Select Remote Learning Mode:
- Press the button corresponding to remote programming (refer to the control board labeling if available).
4. Press the New Remote Button:
- Press and hold a button on the new remote until the controller LED confirms programming (usually by flashing or turning solid).
5. Exit Programming Mode:
- Press the programming button again or wait for timeout (LED will turn off).
If the system requires the master remote to authorize adding new remotes and it is not available, you may need to reset the controller to factory defaults or use a programming cable or keypad (if supported) to add remotes.
Specific steps may vary by firmware version. If these steps do not work, consult the control board directly for labeled instructions.
This answer is automatically generated