The Test Button - Canon AXIS 1650 User Manual

Section 10
Factory Default
Important:
Canon BubbleJet
Printers
AXIS 1650 User's Manual

The Test Button

The test button is located on the front right hand side of the print server
and is used to perform a Factory Default:
1. Remove the power adapter to switch off the print server.
2. Press and hold down the test button, while you reconnect the power
adapter.
3. Continue to hold down the test button until the network indicator
remains constantly lit. This should take about 20 seconds.
4. Restart the print server by disconnecting and reconnecting the power
adapter.
• A factory default will reset all print server parameters and settings to
their default values except Node address (NODE_ADDR.)
The IP address (INT_ADDR.) will be reset to default 192.168.0.90
•
If the AXIS 1650 is connected to a Canon BubbleJet printer, the test
button can be used for the following operations:
• Print a Test Page
Press the test button once to print a test page. The test page contains
basic information about the print server. It is recommended that you
print a test page every time you connect the print server to a printer
• Perform a Factory Default
See description above.
The Test Button
61