DeWalt DW168F Manual page 6

applICaTIon
MoDEl
TypE
Max. hoRsEpoWER*
ToTal DIsplaCEMEnT
BoRE anD sTRokE
RaTED spEED
Max no loaD spEED
IDlE spEED
DRy WEIGhT
DIMEnsIons (l x W x h) In (mm)
MounTInG FlanGE
CoMpREssIon RaTIo
IGnITIon sysTEM
spaRk pluG
CaRBuREToR
aIR ClEanER
luBRICaTInG sysTEM
oIl CapaCITy
sTaRTInG sysTEM
sToppInG sysTEM
FuEl usED
FuEl Tank CapaCITy
p.T.o. shaFT RoTaTIon
CRankshaFT pTo
GoVERnoR
FuEl lInE
FUEL FILTER
on/oFF sWITCh
* Gross horsepower (HP). This horsepower rating represents the maximum output under laboratory conditions at 3600 RPM in accordance with SAE
(Society of Automotive Engineers) J1995 and should be used for comparison purposes only. Actual engine output will be lower and will vary depending
on the application, speed and other variables including altitude and temperature.
CoMpREssoR
DW168F-2E
Single Cylinder, 4 Stroke, OHV, Spark Ignition, Air Cooled
6.5 hp
196 cc
68 x 54 mm
3400 rpm
3600 rpm
2400 rpm
33 lbs. (15 kg)
15.7 x 13.0 x 13.4 (400 x 330 x 340)
flange A per SAE J609a
8.5 to 1
Transistorized magneto Ignition
NGK (BP6ES, BPR6ES)
float type, adjustable idle speed
Standard Semi-dry (foam+paper), high mount
Splash
.507 qt (480 mL)
Recoil, 10 o'clock position
Ignition primary circuit ground
Regular gasoline (86 octane, up to 10% ethanol)
0.95 gal (3.6 L)
Counterclockwise (from P.T.O. side)
Ext. #3 per SAE J609a (3/4" key way PTO)
mechanical, centrifugal flyweight type, variable speed
Low permeation, per SAE J1737 at 40º C or higher
Equipped on recoil base
DW177FD-E
9 hp
270 cc
77 x 58 mm
3400 rpm
3600 rpm
2400 rpm
57.3 lbs. (26 kg)
16.9 x 15.6 x 16.1 (430 x 395 x 410)
flange b per SAE J609a
8.2 to 1
Transistorized magneto Ignition
NGK (BP6ES, BPR6ES)
float type, adjustable idle speed
Standard Semi-dry (foam+paper), high mount
Splash
1.06 qt (1000 mL)
18 V Electric motor and
recoil starter 10 o'clock position
Ignition primary circuit ground
1.56 gal (5.9 L)
Counterclockwise (from P.T.O. side)
Ext. #4 per SAE J609a (1" key way PTO)
In gas tank only
Equipped on recoil base
6