Setting The Ip Address - MELAG MELAtherm 10 Technical Manual

Setting the IP address

NOTICE
Those setting up the (practice) network will require in-depth understanding of the
network technology.
Handling errors of IP addresses can result in malfunctions and data loss in your user
network.
n
IP addresses may only be set by the (practice) network system administrator.
The device is equipped as standard with IP addresses which all belong to a common network with the sub-
net mask stated in the table "Pre-setting of the IP addresses in the device ex works". Observe the following
before integrating the device in a present (practice) network (and only then!):
The IP addresses listed in the table "Pre-setting of the IP addresses in the device ex works" must not
u
be assigned to the (practice) network yet.
u The device cannot be automatically administered in a dynamic (practice) network (i. e. a DHCP
network).
Presetting of the IP addresses in the device ex works
Device
MELAtherm IP
Computer
Log printer
[Client3]
Gateway IP
Subnet mask
1. Working in the SETUP MENU, press
2. Press to open the menu.
3. Press repeatedly to navigate to LAN TCP/IP FTP.
4. Press to open the menu.
5. Press repeatedly to navigate to the required output medium, e.g. MELAtherm IP.
6. Press to change the IP address.
7. Press repeatedly to switch to the corresponding number block.
8. Press to change the selected number block. The number block flashes.
9. Press or to reduce or increase the value.
10. Press to save the new value. The value no longer flashes.
PLEASE NOTE
Holding the relevant key
IP address
192.168.40.10 Preset works side
192.168.40.140 Preset works side
192.168.40.240 Preset works side
[192.168.40.144] [..] not yet used / cannot be changed
192.168.40.244 Not relevant within a network
255.255.255.0 Possibly to be taken over by customer network
to navigate to Autom. logging.
or accelerates the decrease / increase.
Remarks
6 Settings
29