Sealey PPD100 Quick Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Wear eye
Refer to
instructions protection
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Stop the engine and disconnect the spark plug before changing accessories or performing any maintenance.
‰
WARNING! DO NOT operate the driver if damaged. Replace or repair using recommended parts only. Unauthorised parts may
‰
be dangerous and will invalidate your warranty. Use authorised Service agent only.
Keep the driver in good condition. Regular maintenance will give the best and safest performance.
9
Wear appropriate PPE when using driver.
9
DO NOT allow children or untrained persons to operate the driver. Children should be supervised to ensure that they DO NOT play
8
with the machine.
The machine can be used by people with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
9
have been given supervision or instruction concerning use of the machine in a safe way and understand the hazards involved.
DO NOT jam the operating trigger in the operating position and DO NOT pull the trigger without holding the driver firmly in both hands.
8
DO NOT use the driver if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
When not in use, disconnect the spark plug. Drain off any unused fuel into suitable container and dispose of according to local
9
regulations. Clean and dry the driver and store in case.
1.2. ENGINE SAFETY
WARNING! Check the engine oil level before each start-up. Only use approved oil. Never operate the engine with insufficient oil.
‰
WARNING! DO NOT touch spark plug or plug lead whilst the engine is running; severe, potentially fatal, electric shock may result.
‰
Ensure that only the correct fuel type and grade is used.
9
DO NOT check ignition system by removing the spark plug or spark plug lead. Use specific tester or contact service agent.
8
DO NOT operate the driver in an enclosed area as the motor exhaust fumes are a health hazard. Always ensure adequate ventilation.
8
DO NOT leave the driver unattended whilst operating, and DO NOT remove the fuel cap whilst the engine is running.
8
DO NOT refuel the engine whilst it is running. Stop the engine and allow it to cool for two minutes before attempting to refuel.
8
DO NOT refuel in a closed or poorly ventilated environment as there is a danger of explosion or fire. Refuel outdoors only.
8
DO NOT smoke or place the driver near any naked flames whilst re-fuelling.
8
DO NOT operate driver if there is a fuel leak. Move the unit and avoid using until the leak has been fixed and the machine is dry.
8
DO NOT start the engine if there are any flammable materials near the exhaust system or in the path of the exhaust gases.
8
DO NOT block the engine ventilation grilles.
8
Ensure engine fuel is stored in an approved container.
9
For long term storage ensure the fuel is drained and that the driver is adequately protected against frost.
9
DO NOT operate the engine with the air filter removed.
8
DO NOT touch the engine during or after use. To avoid burns, allow it to cool before handling.
8
2. INTRODUCTION
Heavy-duty and easy-to-use post driver, designed to knock posts up to Ø100mm diameter in to the ground. Powered by a lightweight, compact
and powerful 2-stroke 52cc air cooled single cylinder engine. Recoil start and a fuel capacity of 1.3L. Supplied with three sets of post rings: 20
x Ø49mm, 50 x Ø69mm, 70 x Ø100mm, allowing the machine to be used with a wide range of diameter posts. Supplied complete with storage
case with integral wheels for ease of transport, as well as full tool kit, spare grease and fuel mixing container.
3. SPECIFICATION
Model No.: ................................................................PPD100
Engine capacity: ............................................................. 52cc
Engine type: ...................... single cylinder air cooled 2-stroke
Fuel consumption: .......................................................0.6L/hr
Fuel tank: ............................................... 2-Stroke 25:1 (1.3L)
Impact energy: ............................................................ 20-55J
Impact frequency: ............................................. 700:1350rpm
Maximum power: .............................................. 2HP 9000rpm
Maximum torque: ..........................................2.5Nm 5000rpm
Noise rating: ................................................. LWA112, 1dB(A)
© Jack Sealey Limited
100MM 2-STROKE PETROL POST DRIVER
MODEL NO:
Wear protective Wear safety
gloves footwear
Original Language Version
PPD100
Wear protective Wear ear
clothing protection
Vibration/Uncertainty ................................. 13.89m/s²/1.5m/s²
Hot surfaces
PPD100 Issue 1 29/03/21