Yamaha S20 Service Information page 33


Warm up the machine (before wrapping the plastic wrap)
If it is before unwrapping the
plastic wrap, put the drier between
the mounter and the wrap to warm
up the mounter and the air inside
the wrap. In this way, the mounter
can be warmed up effectively.
If the machine is covered with the
plastic wrap, the condensation
occurs on the outer surface of the
wrap, and the drier is not required.
After a while, cut the plastic wrap with
scissors and unwrap it from the top.
Service Information
SI1604009E-002= S20, S10, M20, M10 and D10 installation procedures
33/34
For Service Engineer
Wrap the plastic wrap around
the machine from bottom up
before shipment.