Meva Mammut XT Manual page 2

Wall formwork
90° corner – Two-sided tying
Besides central tie holes, the 50
and 75 cm Mammut XT panels
(Fig. 41.1) also have conical
anchor sleeves in the frame.
These allow two-sided tying at
the corners (Figures 41.2 and
41.3).
Attention
Unused tie holes must always
be closed with plug D35/38 or
alternatively with XT sealing cone
(10) with a pressed-on plug D20
(see page XT-18).
Description Ref. No.
XT sealing cone ..................... 29-902-34
XT sealing cone 10 ................ 29-902-35
Plug D35/38 .......................... 29-902-71
Plug D20, red ........................ 29-902-63
Technical Instruction Manual / Status September 2018
Frame tie hole
Central combination tie hole
Mammut XT panel 50 or 75 cm
with frame tie hole
Fig. 41.1
Mammut XT inside corner with tie hole
Fig. 41.3
Additional frame tie hole
Mammut XT
Fig. 41.2
Mammut XT outside corner
Mammut XT panel 50 or 75 cm
XT-41