ABB Busch-AudioWorld Product Manual page 35

The behaviour of the alarm call and snooze function depends on the switching state of the
device. Four possible switching states are listed in the following.
Case A
Behaviour and functions:
When the alarm time is reached, the radio is interrupted and the signal tone is output (alarm mode).
■
– The volume of the signal tone changes according to the ramp function.
– The volume increases from 20% to 100% of the maximum volume.
– The signal tone lasts for 20 seconds at 20%. Then it increases every second for approximately
25 seconds until the maximum volume is reached.
Display output in alarm mode:
■
– "Alarm"
The alarm mode ends automatically after 1 minute.
■
The signal tone can be stopped with any button (snooze function).
■
– This switches the device back into the play mode and the radio plays again.
– After 5 minutes the device switches automatically back into the alarm mode.
– This process is repeated 3 times.
– There are three ways to stop the repeats early (to deactivate the alarm function):
– Press the "OFF" button long (approx. 2 seconds) during the signal tone.
– Press the "OFF" button during the time between the two signal tones. This also switches the
radio off, since it is in playing mode between the signal tones.
– Deactivate the alarm clock in the configuration menu of the device, see chapter 9.3.4 "Menu
"Alarm clock" - "Alarm clock"" on page 54. The alarm call function is then fully deactivated. If
the alarm clock is to operate again the next day, it must be switched on again.
Table 4: Alarm clock / Snooze function Case A
Case B
Behaviour and functions:
The behaviour and functions are the same as in Case A.
■
– When the alarm time is reached, the radio is interrupted and the beep is output as signal tone.
Table 5: Alarm clock / Snooze function Case B
Case C
Behaviour and functions:
The behaviour and functions are the same as in Case A.
■
– The radio is off between the signal tones.
Table 6: Alarm clock / Snooze function Case C
Case D
Behaviour and functions:
The radio switches to the program position used last.
■
Product manual 2CKA001473B5281
The radio is switched on and is playing.
■
"Beep" has been set as signal tone.
■
The alarm time has been reached.
■
The radio is switched on and is playing.
■
"Radio" has been set as signal tone.
■
The alarm time has been reached.
■
The radio is switched off.
■
"Beep" has been set as signal tone.
■
The alarm time has been reached.
■
The radio is switched off.
■
"Radio" has been set as signal tone.
■
The alarm time has been reached.
■
Operation
│35