Light Kit Fitter Assembly Installation - Harbor Breeze LP8072LAZ Manual

BLADE INSTALLATION (Continued)
2. Position the blade (L) over the blade holder
arm (I) with threaded posts showing. Make
sure the bottom edge of the blade (L) is fully
seated against the blade holder arm (I).
Tighten washer-head screws (BB) with fiber
washers (CC) to secure the blade (L) to the
blade holder arm (I). (Fig. 2)
Hardware Used
Washer-Head
BB
Screws
Fiber
CC
Washers
3. Attach blade holder arms (I) to the hub of motor
assembly (A) using screws (AA). (Fig. 3)
NOTE: Periodically check blade holder hardware
and resecure if necessary.
WARNING
To reduce the risk of personal injury, do
not bend the blade holders when install-
ing, balancing the blades or cleaning the
fan. Do not insert foreign objects in
between the rotating blades.
Hardware Used
Screws
AA

LIGHT KIT FITTER ASSEMBLY INSTALLATION

1. Remove one of the three screws in the support
bracket of the motor assembly (A). Slightly
loosen the remaining two screws. Assemble
the light kit fitter assembly (G) to the housing
support bracket of motor assembly (A) using
the two key slots in the light kit fitter assembly
(G). Replace the third screw and secure all
three screws. (Fig. 1)
x 10
x 10
x 10
12
2
CC
BB
I
L
3
A
1
A
AA
I
H
G